 |
 |
 |
 |
||
 |
 |
 |
 |
||
 |
 |
 |
 |
||
 |
 |
 |
 |
||
 |
 |
 |
| General Specifications | |||
| Heron 2.2 | Heron 3.0 | Heron Q | |
| Electrical Rating (single phase) | 240V, 50Hz | 240V, 50Hz | 240V, 50Hz |
| Nominal cooling capacity | 2.7kW | 3.2kW | 3.2kW |
| Nominal heating capacity* | 1.5kW | 1.5kW | 3.2kW |
| Maximum rated current - cooling | 4.0A | 6.5A | 5.5A |
| Maximum rated current - heating | 6.5A | 6.5A | 5.5A |
| Maximum L/R current | 20A | 20A | 20A |
| Maximum air delivery | 110 l/s | 138 l/s | 138 l/s |
| Installed weight | 34kg | 40kg | 40kg |
| * for Heron 2.2 & Heron 3.0 this is delivered heating output | |||
| Dimensions | |||
| Heron 2.2 | Heron 3.0 | Heron Q | |
| Air Handler (evaporator) height * | 228mm | 228mm | 228mm |
| Air Handler width | 390mm | 390mm | 390mm |
| Air Handler depth * | 240mm | 240mm | 240mm |
| Condenser height | 235mm | 765mm | 765mm |
| Condenser width | 460mm | 460mm | 454mm |
| Condenser depth | 440mm | 220mm | 290mm |
| * Note: for installation of air handler allow 70mm in addition to height shown to allow for correct drainage, and allow a minimum of 70mm (Heron 2.2) or 90mm (Heron 3.0 and Heron Q) in addition to the depth shown for sufficient air flow. | |||
Sizing
The Heron is recommended for vans up to 26 cubic metres (Heron 2.2) and 36 cubic metres (Heron Q and Heron 3.0), but assumes that walls and ceilings are insulated with a minimum of 25 mm of rock wool or foam. Windows should all have shades or curtains as a minimum.
If the van is to be used mainly in extreme conditions (40º C plus or high humidity) then be conservative. Ensure the best insulation is installed, consider double glazed windows and use the unit only on vans of 6 metres and 4.8 metres respectively.
Installation Note
Aircommand strongly recommends the use of an experienced installer for fitting either model Heron. Also, in most states of Australia it is a requirement by law that connection of refrigerant lines be carried out by a licensed tradesperson.
